4.
Remove the battery (see
5.
Disconnect the WLAN module antenna cables from the WLAN module (see
6.
Remove the following components:
●
Service door (see
●
Top cover (see
To remove the display assembly:
1.
Disengage the adhesive and disconnect the display panel cable (1) from the system board.
2.
Remove the display panel cable from its routing path (2).
3.
Release the wireless antenna cables from the clips (3) built into the base enclosure.
CAUTION:
display assembly can result in damage to the display assembly and other computer components.
4.
Remove the five Phillips PM2.5×5.0 screws (1) that secure the display assembly to the computer.
62
Chapter 4 Removal and replacement procedures
Battery on page
Service door on page
Top cover/keyboard on page
Support the display assembly when removing the following screws. Failure to support the
43).
49)
55)
WLAN module on page
52).