IP Camera Web-Client
Alarm and Audio
Alarm Settings
Audio Settings
64
Connect external devices such as sirens or flashing lights to the alarm output connector to
signal camera users that an alarm is activated. See
information. Set the Alarm Output as Normally Open or Normally Close.
When alarm inputs are connected, the camera triggers an alarm only when the normal state
(open or closed) changes. An alarm message appears on the Web-Client screen (see
Figure
) to notify the operator.
Your network camera supports bi-directional audio. There are two supported voice band
channels that function in full duplex mode. Connect industry-standard line level audio input
and output to the back of your camera. See
information.
Audio configuration for your network camera is straightforward.
Figure 4-16
Audio Settings
To listen to or capture audio from the camera, enable the Camera to Client (PC) check box
for the appropriate stream (
the Client (PC) to Camera check box.
Connecting Alarms
on page
Connecting Audio
on page
). To listen to audio from the client (PC), enable
26
for more
26
for more