Alarm (Menu => Alarm) - Honeywell ScanDome III HSDC-252 Series Operation & Programming Manual

Follow the steps below to program the Tours:
1. Press MENU => FUNCTION => TOUR, Short Cut: TOUR MENU to display the main menu
on the monitor. No. + SHFT+TOUR will open directly Tour No.
2. Choose an empty location of function by pushing the Joystick up or down.
3. Stored Preset view can be recalled by pressing Prst button, the camera will move to the
stored Preset view.
4. To place predefined functions as a Tour, press the function buttons (such as Tour, Ptrn,
or Scan ,Prst ). Then select function No. by twisting the Zoom handle. (Programmed
function No. will be scrolled). To remove functions from the Tour, press the HOME or Off
button, blank position mark (- - -) will be displayed. You can overwrite the programmed
position.
5. Repeat Step 2 through 4 for each desired position. Each title will be displayed on top of the
line.
6. Up to 8 Presets, Tours, Patterns Scans can be selected for a Tour. You can expand the
Tour sequence by calling other programmed tours. Push the Joystick handle to right or
left while the cursor is on the top of the line (TOUR 01) to select another page of the Tour
menu. (TOUR 01)
7. You can enter a title for the selected Tour by twisting the Joystick while the cursor is on
the top of the line (TOUR 01). Rotate the handle clockwise or counterclockwise to scroll
through the alphanumeric characters. Push the handle to the right or left to select the next
or previous digit.
8. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the program
without saving.
NOTE: All functions should be programmed before being referred to in the tour menu. Otherwise
functions won't be selectable by item 4 in the procedure.
3.2 ALARM (MENU => ALARM)
Locate the cursor on ALARM item in the main menu and push the joystick to the right for
ALARM programming of the camera.
Main Menu
Function
Alarm
Screen
Camera
Setup
Exit
23