Table of Contents
Advertisement
Step 8. Sealing the wiring
Document 800-05620 Rev C
04/10
Figure 2-8
Normal Alarm States
Normally closed
Connect external devices such as sirens or flashing lights to the alarm output connector to
signal users that an alarm is activated. See
Figure 2-9
Alarm Connection
Audio
The alarm output can be configured to provide normally open or normally closed contacts
(see
Device Settings
on page
12 VDC @ 0.5 A.
Connecting to a Network via CAT5 Ethernet Connector
The main video connection for your camera is made through the Ethernet network
connection. Connect the CAT5 Ethernet connector (see
network using an Ethernet (10Base T, 100Base TX) cable.
Note
You can connect your camera to a network or connect it directly to a PC or
laptop using a crossover cable between the camera and the PC or laptop.
To prevent moisture from entering the housing, you should apply the appropriate sealant
around the conduit entry and mounting screws.
HD4 EQUIP Series IP Dome Cameras User Guide
Normally opened
Figure 2-9
Alarm
In
Out
+
51
to configure the alarm output). Contacts will be rated for
for alarm connection.
+
–
Figure 2-6
on
page
25) to your
27
Advertisement
Table of Contents
