Connecting To A Video Monitor; Connecting Audio And Alarms; Figure 2-6 Audio And Alarm Pins - Honeywell HD4DIP Reference Manual

Connecting to a Video Monitor

Connecting Audio and Alarms

Document 800-04191 Rev A
06/09
The analog video connection (see
used during installation to position, aim and focus the camera, as needed. Connect the
video connector from the camera to the video input connector on your spot monitor.
Figure 2-6 Audio and Alarm PINs
1
2 3
Table 2-1 Audio and Alarm Connector PIN Definitions
PIN Definition
1 Audio In +
2 Audio In -
3 Audio Out +
4 Audio Out -
5 Alarm In +
6 Alarm In -
7 Alarm Out +
8 Alarm Out -
Connecting Audio
The HD4DIP(X) Network Camera supports bi-directional audio. There are two supported
voice band channels that function in full duplex mode. The camera can transmit audio from
the camera to the client (PC) using any audio source that provides an industry standard line
level input (see the terminal strip as depicted in
audio from the client (PC) and provide an industry standard line level output (3.5 mm stereo
or mono jack) suitable to connect to audio devices. Audio input and output have 600 Ohm
impedance. See Configuring Audio
HD4DIP Network Camera V2.1 Reference Guide
Figure 2-4) is available as a test output and should be
4 5 6
Figure 2-5). The camera can also receive
on page 61 to configure audio options.
8
7
25