Table of Contents
Advertisement
Checkpoint
82h
83h
84h
85h
86h
87h
88h
89h
8Ch
8Dh
8Fh
91h
95h
96h
97h
98h
99h
9Ah
9Bh
9Ch
9Dh
9Eh
A2h
Code Description
The keyboard controller interface test completed. Writing the command byte and
initializing the circular buffer next.
The command byte was written and global data initialization has completed.
Checking for a locked key next.
Locked key checking is over. Checking for a memory size mismatch with CMOS
RAM data next.
The memory size check is done. Displaying a soft error and checking for a
password or bypassing WINBIOS Setup next.
The password was checked. Performing any required programming before
WINBIOS Setup next.
The programming before WINBIOS Setup has completed. Uncompressing the
WINBIOS Setup code and executing the AMIBIOS Setup or WINBIOS Setup
utility next.
Returned from WINBIOS Setup and cleared the screen. Performing any
necessary programming after WINBIOS Setup next.
The programming after WINBIOS Setup has completed. Displaying the power on
screen message next.
Programming the WINBIOS Setup options next.
The WINBIOS Setup options are programmed. Resetting the hard disk controller
next.
The hard disk controller has been reset. Configuring the floppy drive controller
next.
The floppy drive controller has been configured. Configuring the hard disk drive
controller next.
Initializing the bus option ROMs from C800 next. See the last page of this
chapter for additional information.
Initializing before passing control to the adaptor ROM at C800.
Initialization before the C800 adaptor ROM gains control has completed. The
adaptor ROM check is next.
The adaptor ROM had control and has now returned control to BIOS POST.
Performing any required processing after the option ROM returned control.
Any initialization required after the option ROM test has completed. Configuring
the timer data area and printer base address next.
Set the timer and printer base addresses. Setting the RS-232 base address next.
Returned after setting the RS-232 base address. Performing any required
initialization before the Coprocessor test next.
Required initialization before the Coprocessor test is over. Initializing the
Coprocessor next.
Coprocessor initialized. Performing any required initialization after the
Coprocessor test next.
Initialization after the Coprocessor test is complete. Checking the extended
keyboard, keyboard ID, and Num Lock key next. Issuing the keyboard ID
command next.
Displaying any soft errors next.
B-5
:
Advertisement
Table of Contents
