Table of Contents
Advertisement
Table 4-8. I/O Device Configuration Submenu
Menu Item
Serial Port1 Address
Serial Port2 Address
Menu Item
View Event Log
Mark All Events as
Read
Clear Event Log
Menu Item
Remote Access
Serial Port Number
Serial Port Mode
Flow Control
Redirection After
BIOS POST
Terminal Type
VT-UTF8 Combo Key
Support
Sredir Memory
Display Delay
Description
This option specifies the base I/O port address and Interrupt Request address of
serial port 1. The options are D
Select D
to prevent the serial port from accessing any system resources.
ISABLED
When this option is set to D
unavailable.
Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address and
IRQ 4 for the interrupt address.
This option specifies the base I/O port address and Interrupt Request address of
serial port 2. The options are D
Select D
to prevent the serial port from accessing any system resources.
ISABLED
When this option is set to D
unavailable.
Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and
IRQ 3 for the interrupt address.
Table 4-9. DMI Event Logging Submenu
Description
Highlight this item and press <E
Highlight this item and press <E
Select Yes and press <E
N
to verify.
O
Table 4-10. Console Redirection Submenu
Description
Allows you to E
NABLE
will appear:
Selects the serial port to use for console redirection. Options are COM1 and
COM2.
Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8,
1), (38400 8,
, 1), (19200 8,
N
Selects the flow control to be used for console redirection. Options are None,
H
and S
ARDWARE
OFTWARE
Options are D
(no redirection after BIOS POST), B
ISABLE
(redirection during POST and during boot loader) and Always (redirection
always active). Note that some OS's may not work with this set to A
Selects the type of the target terminal. Options are ANSI, VT100 and VT-UTF8.
Allows you to Enable or D
VT100 terminals.
Use this setting to set the delay in seconds to display memory information.
Options are No Delay, 1
, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3.
ISABLED
, the serial port physically becomes
ISABLED
, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3.
ISABLED
, the serial port physically becomes
ISABLED
> to view the contents of the event log.
NTER
> to mark all events as read.
NTER
> to clear all event logs. The options are Y
NTER
or Disable remote access. If enabled, the settings below
, 1) and (09600 8,
N
.
VT-UTF8 combination key support for ANSI/
ISABLE
, 2
and 4
SEC
SECS
SECS
4-7
Chapter 4: BIOS
, 1).
N
L
OOT
OADER
LWAYS
.
and
ES
,
N
.
Advertisement
Table of Contents
