Transceiver Unit - Furuno FSV-84 Installation Manual

2.5 Transceiver Unit

2.5.1 Fabrication of 38P connector 00-8016-038-313761HV (CN-B101)
Pass the cable (10S2158) from the processor unit (FSV-8402) through the cable clamp on
the transceiver unit (FSV-841) and connect it to CN-B101.
Shorten the unused wires appropriately and treat their ends with vinyl tape to prevent short
circuit.
Positioning guide pins
Use the tool (Type: 10-910-0179-0) shown below to position guide pins.
Guide Pin
Guide Pin A (large)
Guide Pin B (small)
2-14
400
45
Shield
40
Vinyl Sheath
Armor
Core
Insulating Tape
After exposing cores,
wind shield around the armor.
Fabrication of cable for 00-8016-038-313761HV
Assembling 38P connector
Connector
CN-B101
1
1
Anticorrosive
Sheath
Guide Pin A
Position No.
Guide Pin A
(Large)
Tool
Guide pin insertion tool (notch in head)
Guide Pin B
Guide Pin B
(Small)