Table of Contents
Advertisement
Mounting procedure
1. Unfasten two bolts from the bottom of the front side of the processor unit. Pull the unit
toward you to separate it from the mounting base.
2. Use six bolts (supplied as installation material) to fix the mounting base.
3. Place the processor unit in front of the mounting base.
4. Push the unit forward until it touches the end of the mounting base.
5. Refasten two bolts removed at step 1 to fix the unit to the mounting base.
Unfasten two bolts
1.3 Monitor Unit (option)
Mounting considerations
• The monitor unit is designed for mounting on a tabletop.
• Locate the monitor unit where it can be easily operated while viewing the screen and
operating the control unit.
• Locate the monitor unit out of direct sunlight and away from heat sources because of heat
that can build up inside the cabinet.
• Do not locate the equipment where it may be subjected to water splash or rain.
• Be sure the mounting location is strong enough to support the weight of the unit under the
continued vibration which is normally experienced on the ship. If necessary reinforce the
mounting location.
• The length of the monitor cable which runs between the control unit and the monitor unit is
10 m. Keep this distance in mind when choosing a mounting location.
• Leave sufficient space on the sides and rear of the unit to facilitate maintenance.
• Observe the compass safe distances shown on page ii to prevent interference to a
magnetic compass.
1-8
5.5
34
Mounting dimension for processor unit
505
477
200±1
195±1
φ
8
Hide quick links:
Advertisement
Table of Contents
