Technical Data - Sennheiser EK 3041-U Instructions For Use Manual

29 Technical data

Frequency range
Receiver frequencies
Switching bandwidth
Frequency stability
Sensitivity (with HiDyn plus
Squelch treshold
Adjacent channel rejection
Intermodulation attenuation
Antenna inputs / Impedance
Compander system
De-emphasis
Nominal/peak deviation
AF frequency response
Signal-to-noise ratio
Outputs / Power supply
via GA 3041-C:
AF output
Terminating impedance
Power supply
via GA 3041-B:
Power supply
Suitable accupacks
Suitable battery boxes
Limiter (at headphone output only)
THD at 1 kHz and nominal deviation
Temperature range
Dimensions / Weight
In compliance with
50
450–960 MHz
max. 32, pre-programmed to customer
specifications
24 MHz
® ) typ. 10 V for 90 dBA rms SNR
0 to 100 V, adjustable in 5-dB steps
> 70 dB (400 kHz/800 kHz)
2 LEMO sockets / 50
Sennheiser
50 s
50–20,000 Hz
plug-in connector mounted at the bottom.
The connections depend on
the different mounting adaptors:
3-pin XLR + 9 dB (2.2 V rms),
electronically balanced, standard wiring
at pin 2 and 3, + at pin 2, 3 screen/ground
via 4-pin „HIROSE" DC-socket HR 10-7-
R45, pin 1: ground, pin 4 10.5–18 V DC,
approx. 40 mA at 12 V
1.8–4.8 V (internally DC/DC adjusted to
max. 3.2 V), approx. 150 mA at 2.4 V
Sennheiser BA 50 and BA 250
Sennheiser B 50 and B250
switchable: – 10 dB and – 20 dB
– 10 C to + 55 C
120 x 74 x 28 mm / approx. 200 g
ETS 300422
10 ppm (– 10 C to + 55 C)
70 dB
HiDyn plus
40 kHz/ 56 kHz
100 dB(A) at 1 mV
10 k
1 %, typ. 0.8 % for overall device
®
and peak deviation
RF