Preparing The Machine - Vax VCW-01 Instruction Manual

Vax VCW-01 User Guide.qxd
Vax VCW-01

3. Preparing the Machine

Assembling the carpet washer
Stand base in upright position. Push mid-section onto base by
aligning tabs on inside of mid-section with the pockets on the
base (Fig.3/1).
Mid-Section
Tabs
Fig.3/1
Insert 4 lower handle/tool caddy screws and tighten until
secure (Fig.3/2).
Fig.3/2
Slide upper handle down onto unit (Fig.3/3).
Fig.3/3
4
preparing the machine
21/12/07 09:20
Pockets
Cord
Base
Back View
Upper Handle
Page 4
Insert the upper handle screw (as shown) and tighten
until secure (Fig.3/4).
NOTE: Make sure the power cord is out of the
!
way to avoid pinching.
Clean water
tank latch
Clean water
tank handle
Fig.3/4
Caddy Assembly
Align tool caddy with screw holes on mid-section
and base (Fig.3/5).
Fig.3/5
Insert the three (3) tool caddy screws (as shown) and
tighten until secure (Fig.3/6).
Fig.3/6
Clean water
tank latch
Clean water
tank handle
Back View