Advertisement

Vax careline
0870 1129 145
(UK only)
Carpet Washer
Vax model number:
VCW-02
Please read carefully before using this cleaner.
www.vax.co.uk
Always fully extend the mains cable before use.
Retain for future reference.

Advertisement

Table of Contents
loading

Summary of Contents for Vax VCW-02

  • Page 1 Vax careline 0870 1129 145 (UK only) Carpet Washer Vax model number: VCW-02 Please read carefully before using this cleaner. www.vax.co.uk Always fully extend the mains cable before use. Retain for future reference.
  • Page 2 VCW-02 1. Diagram VCW-02 Fig.1/1 1 Carry Handle 8 Solution Dispense Button 2 On/Off Switch 9 Power Cord 3 Dirty Water Tank 10 Attachment Hose 4 Clean Water Tank 11 Hose Wrap 5 Clean Water/Solution 12 Quick Release Cord Hooks...
  • Page 3: Safety Information

    Do not use with a damaged cord or plug. If the supply cord and/or plug is damaged, they must be replaced by the manufacturer, a Vax Service Agent or similarly qualified persons in order to avoid hazard. Do not pull or carry by the cord, use the cord as a handle, allow the cord to come into contact with hot or sharp surfaces or close a door on the cord.
  • Page 4: Preparing The Machine

    VCW-02 3. Preparing the Machine WARNING: Use only Vax Commercial Carpet Cleaner with this machine. Using other cleaning solutions may cause excessive foaming. Excessive foam will cause the float to shut off the vacuum prematurely. Filling Clean Water Tank Press down on the Lid. Release Latch and tilt lid towards front of cleaner to access the tanks (Fig.3/1).
  • Page 5 user guide 4. Attachments 5. Usage NOTE: Always turn off appliance before IMPORTANT: Do not use the Carpet Cleaner as connecting or disconnecting attachments. a dry vacuum. NOTE: Never leave unit unattended with Connecting Attachments power on. Turn OFF when emptying and filling Connect desired attachment by pressing tool onto the reservoir.
  • Page 6 VCW-02 Turn ON/OFF switch to the “ON” position (Fig.5/2). Fig.5/4 Fig.5/2 Emptying and Cleaning the Dirty Water Tank WARNING: To reduce risk of electric shock Hold the tool approximately 1" above the stained surface. or injury, unplug before removing tank(s) and Press the solution dispense trigger to apply cleaning remove tanks from unit before emptying.
  • Page 7: Troubleshooting

    Reposition cleaning tool, following instructions from ‘Usage’ section of this user guide. Cause: Incorrect cleaning solution. Solution: Use only Vax AAA cleaning solution. PROBLEM: Water escaping from cleaner Cause: Dirty Water Tank is full. Solution: Empty dirty water tank (for instructions see ‘Usage’...
  • Page 8: Technical Specification

    9.00am to 5.00pm An answerphone is available outside of these hours. Dirty water tank volume: 1 litre Any queries or concerns about using the Vax, call the An answerphone is available outside of these hours. Cord length: 10.0m Vax Careline. Calls are charged at the UK national rate.
  • Page 9 user guide This page has been left intentionally blank.
  • Page 10 VCW-02 This page has been left intentionally blank.
  • Page 11 user guide This page has been left intentionally blank.
  • Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the product VCW-02 Carpet Washer is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Table of Contents