Dynacord H 2500 Owner's Manual page 26

PowerH SERIES
CONFIG/DISPLAY SETUP/Temperature Unit: The currently
selected unit for the indication of temperature values is displayed.
Pressing the ENTER button opens the Set Temperature Unit
dialog box, which allows selecting °C (Degrees Celsius) or °F
(Degrees Fahrenheit) by pressing the Up/Down buttons. Pressing
the ENTER button stores the selected unit in memory and the
CONFIG menu reappears on the display.
Structure of the CONFIG/SERVICE menu
CONFIG/SERVICE/Restore Amplifier's Factory Settings: The
power amplifier can be reset to factory settings. Pressing the
ENTER button opens a safety dialog box that lets the user choose
between YES or NO by pressing the Up/Down buttons. If YES has
been selected, pressing the ENTER button resets the power
amplifier to its factory settings. If the user selected NO, all power
amp parameters stay unchanged and the display returns to the
CONFIG. menu.
The following table lists all parameters that are affected by a reset:
CONFIG/SERVICE/Lifetime: This menu item shows the total
running time of the power amplifier (not counting standby times).
26 Owner's Manual
Parameter
Power-On-Delay
Breaker Current (depends on
the supply voltage)
Amplifier Name
LCD Contrast
LCD Brightness High
LCD Brightness Low
LCD Time to Dim
Temperature Unit
Table 3.3: Factory settings of the LC display
Value
0.00 s
16 A (230 V) / 30 A (120 V)
Dynacord H2500
or
Dynacord H5000
50 %
90 %
40 %
Autodim off
°C