Dynacord H 2500 Owner's Manual page 29

MODULE CONFIG/CAN-Baudrate: The currently set CAN baud
rate of the RCM-26 is being indicated. Pressing the ENTER button
opens the Set CAN-Baudrate dialog box, which by pressing the
Up/Down buttons, lets the user select one of the following CAN
baud rates: 10kBaud, 20kBaud, 62.5kBaud, 125kBaud,
250kBaud or 500kBaud.
Pressing the ENTER button stores the selected baud rate in
memory and the display returns to the MODULE CONFIG menu.
CAUTION:
All devices on a specific CAN-BUS must be set to the same baud rate.
MODULE CONFIG/Audio-Input: The currently used audio input
is indicated. Pressing
Select Audio-Input dialog box, which, by pressing the Up/
Down buttons, allows selecting Analog or AES/EBU inputs.
Pressing the ENTER button stores the desired input in memory
and the display returns to the MODULE CONFIG menu.
MODULE CONFIG/Power: The power amp's actual operating
status after using the mains switch is displayed.
If standby mode has been activated via IRIS-Net™ and the power
amplifier has been switched off using the mains switch, the power
amp automatically restarts into standby mode the next time it is
switched on by pressing the mains switch. This menu item allows
booting the power amplifier out of standby mode, even without
IRIS-Net™.
Pressing the ENTER button opens the Set Power dialog box,
which allows the selection of On or Standby operating states by
pressing the Up/Down buttons. Pressing the ENTER button stores
the desired status in memory and the MODULE CONFIG menu
reappears on the display.
the ENTER button opens the
PowerH SERIES
Owner's Manual 29