Dynacord H 2500 Owner's Manual page 139

H5000
Amplifier at rated conditions, both channels driven, 8 Ω loads, unless otherwise specified.
Load Impedance
Maximum Midband Output Power
THD = 1%, 1 kHz, Dual Channel
Rated Output Power
THD < 0.1%, 20 Hz...20 kHz
Maximum Single Channel Output Power
Dynamic-Headroom, IHF-A
Maximum Single Channel Output Power
Continuous, 1 kHz
Maximum Bridged Output Power
THD = 1%, 1 kHz
Maximum RMS Voltage Swing
THD = 1%, 1 kHz
Power Bandwidth
THD = 1%, ref. 1 kHz, half power @ 4 Ω
Voltage Gain, ref. 1 kHz
Input Sensitivity
rated power @ 8 Ω, 1 kHz
THD at rated output power
MBW = 80 kHz, 1 kHz
IMD-SMPTE
60 Hz, 7 kHz
DIM30
3.15 kHz, 15 kHz
Maximum Input Level
Crosstalk
ref. 1 kHz, at rated output power
Frequency Response ref. 1 kHz
Input Impedance active balanced
Damping Factor 1 kHz
Slew Rate
Signal to Noise Ratio Amplifier
A-weighted, 32 dB constant gain
Output Noise, A-weighted
Output Stage Topology
Power Requirements
Power Consumption
1/8 maximum output power @ 4 Ω
Protection
Cooling
Ambient Temperatur Limits
Safety Class
Dimensions (W x H x D), mm
Weight
Depending on the ambient temperature, the unit might not operate continuously at 2 Ω load in Normal Mode or 4 Ω in Bridged Mode.
2 Ω
3500 W 2500 W
- 2100 W
4500 W 3200 W
4100 W 2700 W
- 7000 W
125 V
10 Hz...50 kHz
41 dB / 35 dB / 32 dB (switchable)
0 dBu / +6 dBu / +9 dBu (switchable)
< 0.05%
< 0.05%
< 0.02%
+22 dBu (9.75 V
< -80 dB
< 10 Hz...30 kHz (±1 dB)
20 kΩ
> 400
35 V/μs
111 dB
< -70 dBu
Class H Grounded Bridge (3-stage)
100-240 V, 50-60 Hz / 100 V, 50-60 Hz
1450 W
Audio Limiters, High Temperature, DC, HF, Short Circuit, Back-EMF,
Peak Current Limiters, Inrush Current Limiters, Turn-on Delay, Mains
Circuit Breaker Protection, Mains Over/Undervoltage
Front-to-Rear, 5-Stage-Fans
+5 °C...+40 °C (40 °F...105 °F)
483 x 88.1 x 497.5
14.5 kg (32.0 lbs)
PowerH SERIES
4 Ω 8 Ω
1500 W
1050 W
1800 W
1600 W
5000 W
)
rms
I
139