Jenn-Air W10526082A Installation Instructions Manual page 26

To Convert Oven Broil Burner
1. Remove oven broil burner screw and set aside.
2. Remove the oven broil burner from the oven broil burner
orifice hood. The oven broil burner will hang in the back of the
oven while changing the orifice hood.
B
A. Oven broil burner screw
B. Oven broil burner orifice hood
3. Turn the Number .038 LP gas oven broil burner orifice hood
counterclockwise to remove.
A. Number .038 LP gas oven broil burner orifice hood
4. Install the 1.42 mm Natural gas oven broil burner orifice hood,
turning it clockwise 4 or 5 turns. Do not overtighten.
A. 1.42 mm Natural gas oven broil burner orifice hood
5. Place the oven broil burner on the oven broil burner orifice
hood. Insert the oven broil burner locator pin in the hole in the
oven back.
26
A
A
A
1.42
6. Position the oven broil burner against the roof of the oven
cavity and attach with screw.
A B
A. Oven broil burner orifice hood
B. Oven broil burner
To Convert Surface Burners
1. If they are installed, remove the burner grates.
2. Remove the burner caps.
3. On models with a dual burner, remove the LP choke from the
dual burner.
4. Using a Phillips screwdriver, remove the burner base.
A
B
A. Burner cap
B. Gas tube opening
5. Apply masking tape to the end of a
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A
A. Natural gas orifice spud
B. Dual burner
C. Single burner
C
D
C. Oven broil burner locator pin
D. Oven broil burner locator hole
C
D
C. Burner base screws
D. Burner base
" (7 mm) nut driver to
B C