Jenn-Air W10526082A Installation Instructions Manual page 14

4. Remove 4 locknuts on the motor side of the blower and
remove the bracket.
View from Motor Side of Blower
A
A. Electrical connector
5. Lift and rotate the motor 180° to reposition the electrical
connection.
A. Electrical connector
6. Rotate bracket 90° and secure with 4 locknuts.
14
7. Remove the bracket from the other side of the blower motor,
rotate 90° and secure with 4 locknuts.
8. Mount blower motor to floor using 4 - #8 x ¾" hex head
screws provided.
NOTE: Vent system will be connected after range has been
moved into its final location. See the "Connect Range to
Downdraft System" section.
A
9. Go to the "Make Gas Connection" section.
Top View
B
A
C
A. 2 " (7.3 cm) from back wall
to edge of bracket
B. Mounting bracket
C. Blower