3 INSTALLATION AND POSITIONING
Bring the WAREWASHER to the installation site, remove the packaging and check the appliance and
components for damage; any damage found must be reported to the transporter in writing.
The packaging components (plastic bags, expanded polystyrene, nails, etc.) must not be left within reach
of children and pets since they are potentially dangerous.. All packaging materials used are
environment‐friendly. They can be kept without constituting any hazard, or may be disposed of at a
specialist waste disposal centre. The plastic components suitable for recycling are marked as follows: PE
polyethylene: external packaging film, bag containing the instructions, protective bags. PP
polypropylene: straps. PS expanded polystyrene: corner guards, top of packaging. Wooden and
cardboard components can be disposed of in accordance with the relevant regulations. When the
product is decommissioned it must not be dumped in the environment; it must be disposed of in
accordance with the relevant regulations. All metal parts are in stainless steel and can be removed. The
plastic parts are marked with the symbol identifying the material used.
POSITIONING:
Caution: the indoor system and premises in which equipment for institutions is installed
must comply with the relevant regulations.
The manufacturer declines all liability for direct or indirect injury or damage deriving from failure
to comply with these regulations.
Before installation, check that there are no objects or materials in the vicinity which may be
damaged by steam or splashes of washing solution, or that any such items are suitably protected.
Place the warewasher in the chosen point and remove the protective film.
Level the warewasher (with the aid of a spirit level) on its adjustable feet to ensure that it is
stable; all other mounting solutions must be approved by the manufacturer.
4 INSTRUCTIONS FOR TECHNICAL STAFF
4.1 Plumbing connection
Water supply and drain connection
The water pipelines and electricity supply cable lead out of the bottom
right‐hand corner of the appliance. Connect the water intake hose to a
connector with ¾" threaded fitting, fitting the filter A provided (in
models with acquastop, the filter and ring‐nut form a single unit).
The connection to the water mains must only be made with new
hoses; the use of old or worn hoses is not permitted.
CW/CWH – 511 MDA
8