Using The Monitor; Installing / Changing The Batteries; Connecting The Air Hose; Connecting The Ac Adapter - A&D UA-767NFC Instruction Manual

Installing / Changing the Batteries

1. Slide the battery cover up to open it.
2. Remove the used batteries and insert
new batteries
compartment as shown, taking care that
the polarities (+ and -) are correct.
Use only R6P, LR6 or AA batteries.
3. Slide the battery cover down to close.
CAUTION
Insert the batteries as shown in the battery compartment. If installed
incorrectly, the device will not work.
When (LOW BATTERY mark) blinks on the display, replace all batteries
with new ones. Do not mix old and new batteries. It may shorten the battery
life, or cause the device to malfunction.
Wait two seconds or more after turning the device off, to replace the batteries.
If (LOW BATTERY mark) appears even after the batteries are replaced, make
a blood pressure measurement. The device may then recognize the new batteries.
(LOW BATTERY mark) does not appear when the batteries are drained.
The battery life varies with the ambient temperature and may be shorter at
low temperatures.
Use the specified batteries only.
Remove the batteries if the device is not to be used for a long time.
The batteries may leak and cause a malfunction.

Connecting the Air Hose

Insert the air connector plug
into the air socket firmly.

Connecting the AC Adapter

Insert the AC adapter plug into
the DC jack.
Next, connect the AC adapter
to an electrical outlet.
Use the specified AC adapter.
(Refer to page 18.)

Using the Monitor

into the
Step 3
battery
Air socket
Air connector plug
7
Step 1
Step 2
DC jack
AC adapter plug