Table of Contents
Advertisement
Before measurement, read "Notes for Proper Measurement" on the next page.
Normal Measurement
1.
Place the cuff on the arm (preferably the left arm).
Sit quietly during measurement.
2.
Press the
START
The number of data stored in memory is
displayed.
Zero (0) is displayed blinking briefly.
The display changes, as indicated in the
figure at the right, as the measurement
begins. The cuff starts to inflate. It is normal
for the cuff to feel very tight. A pressure bar
indicator is displayed, on the left edge of the
display, during the inflation.
Note: If you wish to stop inflation at any time,
press the
3.
When inflation is complete, deflation starts
automatically and
indicating that the measurement is in
progress. Once the pulse is detected, the
mark blinks with each pulse beat.
Note: If an appropriate pressure is not obtained, the
device starts to inflate again automatically.
To avoid re-inflation, see "Measurement
with the Desired Systolic Pressure" on
the next page.
4.
When the measurement is complete, the
systolic and diastolic pressure readings
and pulse rate are displayed.
The cuff exhausts the remaining air and
deflates completely.
5.
Press the
START
After one minute of non-operation,
the device will turn off automatically.
Note: Allow at least three minutes between
measurements on the same person.
Measurements
button.
button again.
START
(heart mark) blinks,
button to turn the device off.
Number of data
Starts inflation
Measurement
Systolic pressure
Diastolic pressure
12
At heart level
Press
in memory
displayed
Zero display
Pressurizing
in progress
Pulse rate
Exhausts remaining
air automatically
START
Advertisement
Table of Contents
