Using The Scanner Mode - Olivetti D-COPIA 150 Operation Manual

USING THE SCANNER MODE

Using the Button Manager
Setting up the Button Manager
The scanner driver for this unit includes an STI (Still image) driver and WIA
(Windows Image Acquisition) driver. You can install software that supports the STI
driver and WIA driver to enable scanning using the operation panel of the unit.
The Button Manager accessory software supports the STI driver and WIA driver. Setup
that is required in Windows to use the Button Manager is explained in the following.
Windows XP
1
Click the "start" button, select "Control Panel" and click
"Printers and Other Hardware", and then click "Scanners and
Cameras" in the start menu. Right click the "Olivetti d-Copia
150" icon and click "Properties" in the menu that appears.
2
In the "Properties" screen, click the "Events" tab.
3
Click the "Select an event" button and select "ScanMenu SC1"
from the pull-down menu. Select "Button Manager (OLIVETTI
Personal MFP Series)" in "Start this program" and click
"Apply".
4
Repeat step 3 to set "ScanMenu SC2" through "ScanMenu SC6".
Click the "Select an Event" button and select "ScanMenu2" from the pull-
down menu. Select "Button Manager (Olivetti Personal MFP Series)" in
"Start this program" and click "Apply". Do the same for each ScanMenu
through "ScanMenu6".
When the settings have been completed, click the "Close" button to close
the screen.
When the settings have been completed in Windows, start the Button
Manager. Adjust detailed settings and then scan an image from the unit. For
the procedures for starting Button Manager and adjusting settings, see the
online manual or the help file for Button Manager.
34