Table of Contents
Advertisement
Using the SPF
The SPF is designed to hold up to 30 originals measuring from A5 to A4/Legal and
weighting from 52 to 90 g/m
• Before feeding originals in the original feeder tray, be sure to remove
• Before placing curled or wavy originals into the original feeder tray, be
• The SPF (
• Badly damaged originals may misfeed in the SPF. It is recommended
• Special originals such as transparency film should not be fed through
• Image loss (max. 4 mm) can occur at the leading and trailing edges of
• To stop continuous copying using the SPF, press the clear (
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the
SPF. If the stream feeding mode has been enabled using user program No.4, the
SPF (
) indicator will blink approximately 5 seconds after the last original has
been fed by the SPF. While this indicator is blinking, any new originals placed in the
original feeder tray will be fed and copied automatically. If the stream feeding mode
has been disabled, the start (
set even immediately after completion of a copy run from the SPF. The default
setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.53).
48
2
.
any staples or paper clips from them.
sure to flatten them. If not, original misfeeds may result.
) indicator on the operation panel will light up. If this
indicator does not light up, the originals are not properly set or the
SPF is not properly closed.
that such originals be copied from the original table.
the SPF, but should be placed directly on the original table.
the copies. Also image loss (max. 4.5 mm in total) can occur along the
other edges of the copies.
) key must be pressed each time the originals are
) key.
Original face up
Advertisement
Table of Contents
