Siemens Gigaset C590 IP User Manual page 37

First steps
f.
Instead of a connection, you can also select Sel. at each call. Each time you make a
call, you can then select the connection you wish to use on this handset.
If other handsets are already registered to the base, you are requested to assign
send and receive connections for the handsets. The following is shown in the dis-
play:
Assign connections to handset ?
¤
Perform steps
After successfully configuring the settings, you will briefly see the following display:
Completing the installation
The handset then returns to idle status (an example of the display in idle status):
36
INT 1
Connection for
outgoing calls:
< IP1 >
Back Save
a. to f. for each registered handset.
Connection Assist.
‰
Connection
assignment
complete
If the handset is to make calls via a dif-
ferent connection/phone number:
¤
Press right on the control key v
repeatedly, until the required con-
nection is displayed (in the exam-
ple, IP1).
¤
Press the display key
the settings.
§Save§
to save