Restarting The Base; Checking The Base Mac Address - Siemens Gigaset C590 IP User Manual

Configuring the system settings
The following lists are deleted:
u
SMS lists
u
Call lists
¢ Ï
v
~
§Yes§
After the reset, the base is restarted. The restart takes around ten seconds.
The installation wizard is launched
Resetting the base using a key on the base
As with resetting the base via the menu, all individual settings are reset. The system
PIN is also reset to "0000" and all handsets registered above and beyond the
scope of delivery will be de-registered.
Please note
For instructions on re-registering the handsets after a reset (where applicable),
¢
page
¤
Remove the cable connections from the base to the router
fixed line
¤
Remove the base power adapter from the socket
¤
Press and hold the registration/paging key
¤
Plug the power adapter back into the power socket.
¤
Press and hold the registration/paging key (at least 20 sec.).
¤
Release the registration/paging key. The base has now been reset.

Restarting the base

When the handset is in idle status:
¢
Ï
v
The firmware for the base is then rebooted. This process takes about 20 seconds.

Checking the base MAC address

Depending on your network configuration, you may have to enter your base
MAC address in your router's access control list, for example. You can check the
MAC address on the handset.
In idle status:
v
*#Q5# 2 Q
§Back§
154
¢ ¢
System Base Reset
Enter the system PIN and press
Press the display key.
127.
¢
( page 19).
¢ ¢
System Base Restart
Open menu.
Press keys in sequence.
The MAC address is displayed.
Return to idle status.
§OK§
.
¢
( page 23).
¢
(
¢
( page
¢
( page 21) and
page 19).
5).