Table of Contents
Advertisement
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the SHIFT button and then the CLOCK button. Within
5 seconds, press the SHIFT button and then the MEMORY
button.
2
Within 1 minute, press the PRESET (
lect 24-hour or 12-hour display, then press the SHIFT but-
ton and then the MEMORY button.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
3
Within 1 minute, press the PRESET (
just the hour, then press the SHIFT button and then the
MEMORY button.
Press the PRESET (
by 1 hour. Hold it down to advance continuously.
4
Within 1 minute, press the PRESET (
just the minutes, then press the SHIFT button and then the
MEMORY button.
Press the PRESET (
by 1 minute. Hold it down to advance continuously.
To confirm the time display:
Press the SHIFT button and then the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "0:00" or time will flash when the AC power supply is restored
after a power failure or unplugging the unit.
or
) button to se-
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the "0:00" is not
flashing in step 1, step 2 (for selecting the 24-hour or 12-hour dis-
play) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 24 for details.]
2 Perform "Setting the clock" from the beginning.
05/1/14
or
) button to ad-
or
) button once to advance the time
or
) button to ad-
or
) button once to advance the time
XL-MP40H(H)E1.fm
TINSZA040SJZZ
XL-MP40H
ENGLISH
8
E-8
Hide quick links:
Advertisement
Table of Contents
