Listening To The Memorised Station - Sharp XL-MP40H Operation Manual

Listening to the memorised station

! Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Listening to the radio" on page 15.
2
Press the MEMORY/SET button to
enter the preset tuning saving
mode.
3
Within 5 seconds, press the PRE-
SET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 5 seconds, press the MEM-
ORY/SET button to store that sta-
tion in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
Notes:
" On the remote control, press the SHIFT button and then the
MEMORY button in step 2 and 4.
" The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead dis-
connection.
! To recall a memorised station
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
To select a preset station with the direct number buttons:
Press the corresponding number ("0" - "+10").
Example:
To select 28, press "+10", "+10" and "8".
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired sta-
tion is located.
! To clear a memorised station
1 Recall the memorised station.
2 Whilst it is displayed, press the
SHIFT button and then the MEMO-
RY button.
3 Within 5 seconds, press the SHIFT
button and then the CLEAR button.
! To erase entire preset memory
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 Whilst pressing down the FUNCTION button and the
press the ON/STAND-BY button until "TUCL" appears.
05/1/14 XL-MP40H(H)E2.fm
XL-MP40H
ENGLISH
button,
8
E-16
TINSZA040SJZZ