Fisher-Price POWER WHEELS 74370 Owner's Manual page 16

25
Arrow
Handlebar
Tabs
• Position the vehicle upside down.
• Note the arrow on the underside of the front fender.
• Position the front fender so that the arrow points towards
the front of the vehicle. Slide the fender onto the ends of
the handlebars. Make sure the pegs on the fender slide
over the tabs on the front fork.
26
Shock -
Inner
Tab
Groove
• Using safety scissors, separate the shock set pieces
from the plastic connectors. Dispose of the plastic
connectors properly.
• Fit and hold an inner and outer shock half together.
• While holding the shock together, fit it onto the end of
a handlebar. Push firmly to slide the shock onto the
Assembly
handlebar making sure that the tab on the inner shock
half fits into the groove in the fender.
Front
• Repeat this procedure to slide the remaining shock on
Fender
the other handlebar.
27
.437 (Large Diameter)
Handlebar
Retainer
Tabs
Barrel Side
Front Fork
Round Bushing
• Being careful to keep the shocks correctly positioned,
align the hole in a shock with the hole in the handlebar.
Slide the remaining wheel axle with .437 retainer
(assembled in step 10) through one shock.
Helpful Hint: If the hole in the shock and handlebar do
not align, the front fender is not properly seated on the
front fork. Reposition the front fender to align the holes.
• Fit a round bushing, barrel side first, onto the end of
the wheel axle.
Shock -
Outer
28
Handlebar
Hex Bushings
• Fit two hex bushings into the center hole in the
remaining wheel (see inset).
• While holding the hex bushings in place, position the
wheel between the shocks.
16
• Continue to slide the wheel axle through the wheel.
Wheel
Axle
Shock
Wheel (with Hex Bushings)
Shock
Wheel Axle
Round
Bushing
Shock