Fisher-Price POWER WHEELS 74370 Owner's Manual page 12

9
Right
Exhaust
Pipe
• With the holes aligned, insert six screws to join the
two halves of the right exhaust pipe.
• Tighten the screws using a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 6 through 9 to assemble the left exhaust
pipe (L) to the left side of the vehicle.
10
• Separate the fork axle from the two wheel axles. (The
fork axle is shorter than the wheels axles.) Set the fork
axle aside.
• Place a .437 (large diameter) retainer on a flat surface,
inside up.
• Fit the end of a wheel axle into the retainer.
• Tap the opposite end of the wheel axle with a hammer
to secure the retainer on the axle. Pull on the retainer
to make sure it is secure.
• Repeat this procedure to assemble one .437 (large
diameter) retainer to one end of the other wheel axle.
• Set one of the wheel axles aside for use later
in assembly.
Assembly
Wheel Axle
.437 (Large Diameter)
Retainer
12
11
Wheel
Axle
• Slide an axle bushing (flat side first) on a wheel axle.
12
1
Guide
Guide
3
4
2
• Before applying labels to the wheels, wipe each wheel
with a clean, dry cloth to make sure it is free of dirt and
oils. Make sure your hands are clean.
• Apply labels to both sides of each wheel as shown in
the illustration.
IMPORTANT! Labels 1 and 2 are designed to slightly
overlap; and labels 3 and 4 are designed to slightly
overlap. For each wheel, apply label 1 before applying
label 2 . Align the edge of label 2 with the guide marks
on label 1. Apply label 3 before applying label 4. Align the
edge of label 4 with the guide marks on label 3.
13
Hex
Bushing
• Fit two hex bushings into the center hole in a wheel.
Flat Side
Axle Bushing
1
Wheel
Guide
Guide
Wheel
Hex
Bushing
3
4
2