Table of Contents
Advertisement
36
Handlebar
Harness
See
Inset
Tab
• Fit the handlebar harness behind
the tab in the vehicle frame neck.
37
Steering
Bushing
• Fit the remaining steering bushing onto the top of the
vehicle frame neck.
• Insert two #8 x
3
/
" screws into each end of the steering
4
bushing and tighten.
Assembly
38
Handlebar
Harness
• First, fit the tab on the steering stop into the curved slot
in the lower steering bushing
• Hold the steering stop in place.
Tab
• Then, slide the handlebar assembly on the vehicle frame
neck and over the steering stop
39
.354 Cap Nut
• Place a .354 (small diameter) cap nut on a flat surface,
inside up. Fit the end of the fork axle into the cap nut.
• Tap the opposite end of the fork axle with a hammer to
secure the cap nut on the axle. Pull on the cap nut to
make sure it is securely assembled.
20
Neck of
Vehicle Body
Steering
Stop
.354"
Handlebar
Assembly
.
.
Fork Axle
.354 (Small Diameter)
Cap Nut
Advertisement
Table of Contents
