Power Wheels B9784 Owner's Manual With Assembly Instructions page 15

16
.437"
.437 Cap Nut
• Separate the fork axle from the two wheel axles. (The
fork axle is shorter than the wheels axles.) Set the fork
axle aside for assembly step 39.
• Place a .437 (large diameter) cap nut on a flat surface,
inside up. Fit the end of a wheel axle into the cap nut.
• Tap the opposite end of the wheel axle with a hammer
to secure the cap nut on the axle. Pull on the cap nut
to make sure it is secure.
• Repeat this procedure to assemble a .437 (large
diameter) cap nut to one end of the other wheel axle.
• Set one of the wheel axles aside for assembly step 52.
17
Axle Bushing Flat Side
Wheel Axle
• Slide an axle bushing, flat side first, on the wheel axle.
18
Hex
Bushing
• Fit two hex bushings, barrel side first, into the hole in
the rear wheel.
Assembly
Wheel Axle
.437 (Large Diameter)
Cap Nut
Rear
Wheel
Hex
Bushing
Hex Bushing
19
Axle
Bushing
Groove
Rear Fork Arm
Rear Wheel
(with Hex Bushings)
• Position the vehicle assembly so that the back is
facing you.
• While holding the hex bushings in place, position the rear
wheel between the rear fork arms of the vehicle frame.
• Slide the wheel axle (with axle bushing) through one rear
fork arm, through the wheel (with hex bushings) and out
through the other rear fork arm. Make sure the wheel
axle bushing fits into the groove in the rear fork arm.
20
.437"
.437 Cap Nut
Barrel
• Slide an axle bushing, tube side first, onto the end of the
Side
wheel axle. Make sure the flat end of the axle bushing
fits into the groove in the rear fork arm.
• Fit a .437 (large diameter) cap nut on the end of
the wheel axle. Tap the .437 cap nut with a hammer to
secure it on the end of the wheel axle.
Hint: You may need the help of another adult to support
the other end of the wheel axle.
15 • Pull on the .437 cap nut to make sure the rear wheel
assembly is secure.
Vehicle
Frame
Rear Fork Arm
Back View
Axle Bushing
Tube Side
.437 (Large
Diameter)
Wheel Axle
Back View
Cap Nut