Table of Contents
Advertisement
12
Strut
Rear
Fender
#8-32 x 1
5
/
"
8
Machine Screw
• First, insert a #8-32 x 1
hole in the side of the right strut that is closest to the
rear of the vehicle body, as shown
• Attach an #8-32 acorn nut to the end of the screw,
inside the rear fender. Hand-tighten the acorn nut.
• Then, insert a #8-32 x 1
hole in the side of the right strut that is towards the front
of the vehicle body, as shown
• Attach an #8-32 acorn nut to the end of the screw,
inside the rear fender. Hand-tighten the acorn nut.
• Using an adjustable wrench to hold the acorn nuts
inside the rear fender, tighten the screws.
• Repeat steps 11 and 12 to assemble the left strut to the
left rear fender of the vehicle body.
13
Signal
Strut
Housing
Back View
• Slide a signal housing onto a strut.
• Bend the tab inside the signal housing down.
#8-32 x
Machine Screw
5
/
" machine screw through the
8
.
3
/
" machine screw through the
4
.
Signal
Housing
Bend
Tab
Down
Assembly
14
3
/
"
4
• Align the rib on the signal lens with
the notch in the signal housing.
Fit the lens into the housing.
• Insert a #8 x
and tighten.
• Repeat steps 13 and 14 to assemble the other signal
housing and signal lens to the other strut.
15
Guide
Guide
3
4
2
• Before applying labels to the rear wheel, wipe it with
a clean, dry cloth to make sure it is free of dirt and oils.
Make sure your hands are clean.
• Apply labels to both sides of the wheel as shown in
the illustration.
IMPORTANT! Labels 1 and 2 are designed to slightly
overlap; and labels 3 and 4 are designed to slightly
overlap. For each side, apply label 1 before applying label
2. Align the edge of label 2 with the guide marks
on label 1. Apply label 3 before applying label 4. Align the
edge of label 4 with the guide marks on label 3.
14
Strut
Signal
Lens Rib
Signal
Housing
Notch
Back View
3
/
" screw into the lens
4
1
Wheel
Guide
Guide
Signal
Lens
1
3
4
2
Advertisement
Table of Contents
