Table of Contents
Advertisement
1
Battery
• Remove the two screws holding the battery clamp to the
vehicle body.
• Remove the battery clamp. Set the battery clamp and
screws aside. Do not throw out the battery clamp or
screws. You will use them when installing your battery
(see page 30).
• Remove the battery from the battery compartment.
• Remove and discard any cardboard in battery compart-
ment which may have been added for shipping purposes.
Battery Charging
2
Battery
Clamp
• Plug the charger connector into the battery
• Plug the charger into a standard 120 volt wall outlet
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is "ON".
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each
use of your vehicle. Do not charge the battery longer
than 30 hours.
• Once the battery is charged, pull firmly on the charger
connector to disconnect it from the battery. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your vehicle. Please see the Battery
Installation section on page 30 for detailed instructions on
installing your battery. If your battery is already installed in
your vehicle, simply plug the motor harness connector
into the battery and replace the seat.
10
Battery
P b
Charger
Connector
.
.
Advertisement
Table of Contents
