Using Alarm Input Terminal As Day/Night Switching - Sanyo VCC-WD8574 Instruction Manual

Specifying Alarm Input

Using Alarm Input Terminal as DAY/NIGHT Switching

1 1
1 1
Set "MODE" to "COLOR".
MEMO: Specify this option when you want the switching between
COLOR and B/W mode to be made by any external
sensor or switch through the alarm input, independent on
the ambient brightness.
Note: • You must specify "COLOR" for the "DAY/NIGHT" mode
to enable this setting. (See page 32)
• The setting will take effect after you exit the settings
screen.
• You can select either "OFF" or "OR" alone for
"MOTION" setting. (See page 41)
43
English
ALARM IN SETTING
MODE COLOR
POLARITY NO
MOTION OFF
MOTION SET SET
ZOOM OFF
ZOOM TIME 5S
PRESET OFF
MENU BACK
2 2
2 2
Select "POLARITY" and specify a polarity for the
signal.
Between ALARM
POLARITY
Setting
Open
NO
Close
Open
NC
Close
NO : Normal Open (When closed, switches from COLOR to B/W.)
NC : Normal Close (When opened, switches from COLOR to B/W.)
MEMO: For other settings, see pages 38 – 43.
3 3 3 3
Set "MENU" to "END" and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select "BACK" and
press the SET button.
IN and COM Mode
Terminals
COLOR
B/W
B/W
COLOR