Sanyo VCC-WD8574 Instruction Manual page 42

Specifying Alarm Input
I I I I
Select "DURATION" and specify a time until the
next alarm input becomes enabled.
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M
(S = second, M = minute)
Note: A new detection or an alarm output cannot be performed
until the specified time of duration elapses.
J J J J
Set "MENU" to "BACK" and press the SET
button.
RReturns to the "ALARM IN SETTING" screen.
41
English
MOTION SETTING
MASKING OFF
SENSITIVITY SET
DURATION 5S
PRESET OFF
MENU BACK
K K K K
Select "POLARITY" and specify a polarity for the
signal.
NO : Normal Open (When closed, alarm input is detected.)
NC : Normal Close (When opened, alarm input is detected.)
L L L L
Select "MOTION" and specify the detection logic
of the motion sensor and the alarm input.
OFF : The motion sensor is unused: Detects when an external
sensor responded.
AND : Detects when both the motion sensor and an external
sensor responded. (You cannot select this option when the
"MODE" is specified with "COLOR".)
OR : Detects when either the motion sensor or an external
sensor responded. (During the "COLOR" mode, detection
is solely dependent on the responsiveness of the motion
sensor.)
Note: While the "SENSE UP" capability is enabled, the motion
sensor does not work. If "SENSE UP" has been set to other
than "OFF", this setting is not available. (See page 28)
ALARM IN SETTING
MODE ALM
POLARITY NO
MOTION OFF
MOTION SET SET
ZOOM OFF
ZOOM TIME 5S
DURATION 5S