Set Alarm; Save As Time Signal - Yamaha TNR-W Manual

7. Set Alarm

Sets the time at which the alarm will sound during Interior Mode operation.
●
If the hourly chime and alarm are set to the same time (the alarm minutes are set to "00"), only the alarm will
sound.
■
Range . . . . . . . . . . . . 00:00 — 23:59
■
Default . . . . . . . . . . . 00:00
■
LED Buttons . . . . . . . No display

8. Save As Time Signal

Saves the performance data (active notes and settings) in the current block for use as the
time signal that will play as the hourly chime during Interior Mode operation.
●
If you use this function to change the time signal (hourly chime), the original default time signal will be erased.
To restore the original time signal use the Factory Reset function.
After selecting the block containing the data you want to save as the time signal, press the
[OK] button while this display is showing to save the data as the time signal.
●
Press the [CANCEL] button (or use the jog dial to select "CANCEL" on the LCD and then press the [OK]
button) if you want to cancel the operation.
If you press the [OK] button to execute the operation, "Saving ..." will appear on the display
while the data is being saved.
File data may be irreparably corrupted if you turn off the power or remove the SD Memory Card while
the "Saving..." display is showing.
■
Range . . . . . . . . . . . . OK, CANCEL
■
Default . . . . . . . . . . . OK
■
LED Buttons . . . . . . . No display
Setting Parameters with the Jog Dial
Set Alarm ∞
06:30
SaveAs Time Signal∞
OK
Parameter Settings
■ Interior Menu
104
TENORI-ON Manual