Factory Set - Yamaha A5000 Service Manual

NG :
N G S C S I d e v i c e b a d c o n d i t i o n
Access Error
NG :
N G S C S I d e v i c e r e a d e r r o r
Read Error
NG :
N G S C S I d e v i c e w r i t e e r r o r
Write Error
NG :
N G D ATA c o m p a r e e r r o r
Verify Error
END OF THE TEST
After displaying the result, the test will be finished.
After pressing the [ENC5] STOP, the test will be finished.
54 DRIVE 100MB VERIFY (IDE)
5 4 : D R I V E 1 S E C T O R ( I D E )
D E S T R U C T I V E !
Connect the HDD to the IDE Bus and execute the read/write test of
the 100MB. Execute by pressing the [ENC5] MANUAL and check
that OK is displayed. The MASTER (0)/SLAVE (1) of the drive can
be selected by testing on the [ENC3]. ( The default ID is the ID4.)
The data on the IDE DRIVE may be destroyed, so execute this test
after saving the back up data.
RESULT OF THE TEST
OK :
OK
NG :
NG
END OF THE TEST
After displaying the result, the test will be finished.
After pressing the [ENC5] STOP, the test will be finished.
55 DIGITAL I/O
55: D I G I TA L I / O
Connect the DIGITAL IN terminal and the DIGITAL OUT terminal
and execute the test. Check the test result on the LCD.
RESULT OF THE TEST
OK :
55: D I G I TA L I / O
OK
NG :
55: D I G I TA L I / O
NG
I D 4 AUTO MANUAL
AUTO MANUAL
AUTO MANUAL
AUTO MANUAL
OK
AUTO MANUAL
NG
AUTO MANUAL
END OF THE TEST
After displaying the result, the test will be finished.
56 OPTICAL I/O
56: O P T I C A L I / O
Connect the DIGITAL IN terminal and the DIGITAL OUT terminal
and execute the test. Check the test result on the LCD.
RESULT OF THE TEST
OK :
56: O P T I C A L I / O
OK
NG :
56: O P T I C A L I / O
NG
END OF THE TEST
After displaying the result, the test will be finished.
98

FACTORY SET

9 8 : F A C T O R Y S E T
Set the A5000/A4000 in the factory shipping data.
RESULT OF THE TEST
Execute the factory set and display the following screen.
9 8 : F A C T O R Y S E T
END OF THE TEST
After displaying the result, the test will be finished.
99 EXIT
99: EXIT
Execute the EXIT and finish the test.
D. OTHERS
90 SCSI TERM POWER
Turning on the A5000/A4000 power switch, test can start after more
than 5 seconds. The voltage can be measured the SCSI connector for
the internal cannnot and the DM circuit board of the CN9-26 pin (the
line of the SCSI term power). Check the voltage is over 4.4 V and
under 5.1 V.
When executing this test, the SCSI TERM SW is possible to be on or
off.
A5000/A4000
AUTO MANUAL
OK
AUTO MANUAL
NG
AUTO MANUAL
AUTO MANUAL
OK
AUTO MANUAL
AUTO MANUAL
29