Yamaha MT4X User Manual page 8

7 Controls and Connections
ODD/L: Rotated fully counter-clockwise sends the signal to the odd (1 or 3)
numbered track of the selected track group (ASSIGN keys
channel of the STEREO bus.
EVEN/R: Rotated fully clockwise sends the signal to the even (2 or 4) numbered
track of the selected track group (ASSIGN keys) and to the right channel of the
STEREO bus.
Input select (TAPE - MIC/LINE) key
This key selects the input source for the channel. Pressed in
track corresponding to the channel module (for example, the channel 1 key selects
track 1). In the out position
Channel fader
This linear control is used to set the channel level. For optimal performance and
signal balance, the fader should be positioned between 7 and 8.
AUX RETURN - ASSIGN keys
These keys assign the signal from the AUX
RETURN connectors
bus.
Auxiliary return LEVEL controls
These rotary controls adjust the level of the
auxiliary return signal.
MONITOR SELECT keys
These keys are used to select the group buses,
the stereo bus, and the cue bus signals. The
signals are routed to the MONITOR OUT
connectors on the rear panel and the stereo
PHONES
MT4X.
GROUP: These keys select groups 1 and 3 and
groups 2 and 4 respectively. If you select both
keys, groups 1 and 3 will be sent to the left
channel and groups 2 and 4 will be sent to the
right channel.
STEREO: This key selects the stereo bus signal.
CUE: This key selects the cue bus signals. These
are the playback signals direct from the cassette
tracks. When you are recording, the record
signal is monitored.
CUE LEVEL controls
These rotary controls adjust the level of the
signal from each track before it is sent to the cue
bus.
, the source is the MIC/LINE INPUT connector
to the selected group
connector on the front of the
and to the left
it selects the tape
User's Guide