Yamaha MT4X User Manual page 21

The indicator above the key lights and any flashing REC SELECT - TRACK
indicators will be illuminated.
10) Set the channel fader to the nominal level between "7" and "8" and adjust the GAIN
controls.
Rehearsal
After you have set the recording levels, you should rehearse the overdub to verify and
adjust the settings and cue levels.
11) Press the PLAY key to start the rehearsal.
The indicator above the key lights and the MT4X starts the tape. Start playing.
Tip: Sometimes the pitch of an instrument and the pitch of the previously recorded
tracks is slightly different. If you cannot adjust the pitch of the instrument, you can
compensate for the error with the TAPE SPEED CONTROL
PITCH control can adjust the tape speed by approximately ±10%. During rehearsal,
adjust the PITCH control until you have matched the instrument with the tracks.
12) Press the RETURN TO ZERO key to stop the rehearsal and rewind the tape.
The indicators above the REHE and PLAY keys switch off and the REC SELECT -
TRACK indicators resume flashing.
Record the track
13) Press the REC/PAUSE key.
The indicator above the key lights and any flashing REC SELECT - TRACK
indicators will be illuminated.
14) Press the PLAY key.
The indicator above the key lights and the MT4X starts the tape. Play the part again
Note: To prevent wow and flutter effects, do not accidentally adjust the PITCH control
while you are recording.
15) When the track is complete, press the RETURN TO ZERO key to stop and rewind
the tape.
The indicators above the REC/PAUSE and PLAY keys switch off and the
REC SELECT - TRACK indicators resume flashing.
Check the completed recording
16) Press the PLAY key to playback the tape and check the recording.
17) If the recording needs to be redone, repeat the previous steps.
User's Guide
Recording Functions
-PITCH control. The
20