IMPORTANT:
Transmission problems will arise if the setting for additional sensors is not followed as described above.
Should transmission problems occur, it is necessary to remove the batteries from all units and start again
the set-up from step 1.
HOW TO INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The Temperature Transmitter uses 2 x AA, IECLR6, 1.5V batteries. To install and replace the batteries,
please follow the steps below:
1.
Slide the battery cover downwards and remove.
2.
Insert the batteries, observing the correct polarity (see marking).
3.
Replace the battery cover.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting up procedures. This is because a random security code is
assigned by the transmitter at start-up and this code must be received and stored by
The Weather Station uses 2 x AA, IEC LR6, 1.5V batteries. If the batteries
need to be replaced, the low battery symbol will appear on the LCD.
To install and replace the batteries, please follow the steps below:
1.
Insert finger or other solid object in the space at the bottom center
of the battery compartment and lift up to remove the cover.
2.
Insert batteries observing the correct polarity (see marking).
3.
Replace compartment cover.
33