How To Install And Replace Batteries In The Temperature Transmitter - La Crosse Technology DCF-77 Instruction Manual

5. Once the remote temperature has been received and displayed on
the Weather station, the DCF time (radio controlled time) code
reception is automatically started. This takes typically between 3-5
minutes in good conditions.
Note:
Daily DCF reception is done at 02:00 and 03:00 every day. If the
reception at 03:00 is not successful, then at 04:00 and 05:00 and 06:00
there are other tries, until one is successful. If the reception at 06:00 is
still not successful, then the next try takes place at 02:00 next day.
If reception is successful, the received time will override the manually set
time. (Please refer also to notes on "DCF-77 Radio Controlled Time"
and "Manual Time Setting").
HOW TO INSTALL AND REPLACE BATTERIES IN THE WEATHER
STATION
The Weather Station uses 3 x AA, IEC
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE TRANSMITTER
The Temperature Transmitter uses 2 x AA, IEC LR6, 1.5V battery. To
install and replace the batteries, please follow the steps below:
LR6, 1.5V batteries. When
batteries will need to be replaced,
the low battery icon will appear on
the LCD. To install and replace the
batteries, please follow the steps
below:
1. Lift up the battery
compartment cover.
2. Insert batteries observing
the correct polarity (see
marking).
3. Replace compartment cover.
32