How To Install And Replace Batteries In The Temperature Station - La Crosse Technology WS-9124TWC-IT Instruction Manual

If the signal reception is not successful on the first frequency (915MHz) for
45 seconds, the frequency is changed to 920MHz and the learning is tried
for another 45 seconds. If still not successful the reception is tried for 45
seconds on 910MHz. This will also be done for re-synchronization.
IMPORTANT:
Transmission problems will arise if the setting for additional sensors is not
followed as described above. Should transmission problems occur, it is
necessary to remove the batteries from all units and follow the set-up from
step 1.
HOW TO INSTALL AND REPLACE BATTERIES IN THE
TEMPERATURE STATION
BATTERIES IN THE TEMPERATURE SENSOR
The temperature sensor uses 1 x CR2023, 3.0V
battery. When battery needs replacing, the low battery
icon will appear on the LCD of the Temperature
Station. To install and replace the batteries, please
follow the steps below:
1.
The Temperature Station uses 2 x AAA, 1.5V
Alkaline batteries. When batteries will need to
be replaced, the low battery icon will appear
on the LCD. To install and replace the
batteries, please follow the steps below:
1. Lift up the battery compartment cover.
2. Insert batteries observing the correct
polarity (see marking).
3. Replace compartment cover.
HOW TO INSTALL AND REPLACE
Remove the battery compartment cover at the
back of the sensor.
5