Install Batteries In Outdoor Transmitter; Install Batteries In The Forecast Station - La Crosse Technology 308-1451 Instruction Manual

IINSTALL BATTERIES IN THE FORECAST STATION:
Battery
Compartment
Batteries:
1. Remove battery cover: Slide tab to the right and pull out to remove battery cover.
2. Install three fresh AA batteries according to the polarity markings.
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Lithium, Standard, or Rechargeable Batteries
If the Forecast station does not display indoor temperature after 60 seconds, remove batteries and wait
for at least 60 seconds before repeating the setup process.
INSTALL BATTERIES IN THE OUTDOOR TRANSMITTER:
1. Slide the battery cover down, then lift off the back of the transmitter.
Note: Be careful not to break the tabs on the battery cover.
2. Confirm the channel selector switch is on channel 1.
3. Insert two fresh AA batteries into the transmitter. Observe the
correct polarity (see marking inside battery compartment).
4. Keep transmitter 5-10 ft. from the forecast station during setup.
5. After 15 minutes, if the outdoor temperature shows on the forecast
station, move the outdoor transmitter outside to a shaded location
within range of the forecast station.
15