Low Battery Icon; Power The Weather Station; Install Batteries In The Outdoor Transmitter - La Crosse Technology T83646 Manual

Improper use or unauthorized opening of housing will void the warranty.
If the weather station does not work properly, change the batteries and/or check the AC cord
connection.

Low Battery Icon

Weather station: Icon displays in Indoor LCD section, replace batteries in the weather station.
Transmitter: Icon displays in Outdoor LCD section, replace batteries in the outdoor transmitter.

Power the Weather Station

Battery
Compartment
2 "AA"
Remove battery cover. Slide tab down and pull off to remove battery cover.
1. Install two new AA batteries according to the polarity markings.
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Lithium, Standard or Rechargeable Batteries
If the weather station does not display indoor temperature after 60 seconds, remove adapter and
batteries and wait for at least 60 seconds before repeating the setup process.

Install Batteries in the Outdoor Transmitter

1. Slide the battery cover down, then lift off the back of the transmitter.
2. Insert two new AA batteries into the transmitter. Observe the correct polarity.
3. Keep transmitter 5-10 ft. from the weather station during setup.
4. After 15 minutes, if the outdoor temperature shows on the weather station, you can
move the outdoor transmitter outside to a shaded location within range of the
weather station.
Search for Transmitter
Hold the SENSOR button to search for the outdoor transmitter.
The strength signal icon will animate until the sensor signal is received or for 3
minutes if no signal available.
Model T83646 www.lacrossetechnology.com/support
BACK
VIEW
Battery Cover
Page | 8