Spektrum DX6I User Manual page 67

GENERAl INfORMATION
Servo Precautions
• Do not lubricate servo gears or motors.
• Do not overload retract servos during retracted or extended conditions.Make sure they are able to travel
their full deflection. Overloading or stalling a servo can cause excessive current drain.
• Make sure all servos move freely through their rotations and no linkages hang up or bind. A binding
control linkage can cause a servo to draw excessive current. A stalled servo can drain a battery pack in a
matter of minutes.
• Correct any control surface "buzz" or "flutter" as soon as it is noticed in flight, as this condition
can destroy the feedback potentiometer in the servo. It may be extremely dangerous to ignore such
"buzz" or "flutter."
• Use the supplied rubber grommets and brass servo eyelets when mounting your servos. Do not over-
tighten the servo mounting screws, as this negates the dampening effect of the rubber grommets.
• Ensure the servo horn is securely fastened to the servo. Use only the servo arm screws provided; the
size is different from other manufacturers.
• Discontinue to use servo arms when they become "yellowed" or discolored. Such servo arms may be
brittle and can snap at any time, possibly causing the aircraft to crash.
• Check all related mounting screws and linkages frequently. Aircraft often vibrate, causing linkages and
screws to loosen.
132 SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
General Notes
Radio controlled models are a great source of pleasure. Unfortunately, they can also pose a potential hazard if
not operated and maintained properly.
It is imperative to install your radio control system correctly. Additionally, your level of piloting competency must
be high enough to ensure that you are able to control your aircraft under all conditions. If you are a newcomer to
radio controlled flying, please seek help from an experienced pilot or your local hobby store.
Safety Do's and Don'ts for Pilots
• Ensure that your batteries have been properly charged prior to your initial flight.
• Keep track of the time the system is turned on so you will know how long you can safely operate
your system.
• Perform a ground range check prior to the initial flight of the day. See the "Daily Flight Checks Section"
for information.
• Check all control surfaces prior to each takeoff.
• Do not fly your model near spectators, parking areas or any other area that could result in injury to
people or damage of property.
• Do not fly during adverse weather conditions. Poor visibility can cause disorientation and loss of control
of your aircraft. Strong winds can cause similar problems.
• Do not point the transmitter antenna directly toward the model. The radiation pattern from the tip of the
antenna is inherently low.
• Do not take chances. If at any time during flight you observe any erratic or abnormal operation, land
immediately and do not resume flight until the cause of the problem has been ascertained and corrected.
Safety can never be taken lightly.
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE 133