Spektrum DX6I User Manual page 16

lOW bATTERy AlARM
When the battery voltage drop below 4.3 volts an alarm will sound and the screen will flash.
TRAINER
The DX6i offers a Trainer function that allows the transmitter to operate as a master or slave. The trainer switch is
located on the back left of the transmitter. (The trainer switch is located on the back right on Mode 1 transmitters.)
MASteR
The transmitter can be used as a master but the slave transmitter must have the same programming (i.e. reverse,
travel adjust, dual rates, mixes, sub trims, etc.) as the master.
SlAvE MODE
When using the transmitter as a slave with another DX6i, it's necessary to match all the programmable settings (i.e.
reverse, travel adjust, etc.).
PROGRAMMING USING ThE ROllER
The roller is used to access all programming functions.
• Pressing and releasing the roller accesses/ enters the selected function
• Rolling the roller changes values or selections
TO ACCESS ThE MAIN SCREEN:
Anytime the transmitter is turned on, the main screen will appear.
Reduce photo to 13.5%
MDL6
TO RETURN TO ThE MAIN SCREEN:
From the ADJUST LIST or SETUP LIST screens, pressing and holding the roller for more than three seconds then
releasing the roller will return the display to the main screen.
TO RETURN TO ThE lIST OR SETUP SCREEN:
From the any program function screens, pressing and holding the roller for more than three seconds then releasing
the roller will return the display to the LIST of SETUP screen.
30
MUSTANG
5.0V DN06:00
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
SETUP lIST
The SETUP list contains the programming functions that are normally only used during the initial setup of the
model. (i.e. model type, servo reverse, model name).
Reduce photo to 13.5%
MODEL TYPE
List
ACRO HELI
Model Type (Page 33)
Reduce photo to 13.5%
MODEL NAME
List
MODEL 6
MUSTANG
Model Name (Page 35)
Reduce photo to 13.5%
MONITOR
List
[ ]
THR
AIL
D/R SW:
[ ]
ELE
RUD
CH5 [ ]
AUX
Monitor (Page 37)
Reduce photo to 13.5%
REVERSE
List
THRO-N AILE-N
ELEV-N RUDD-N
GEAR-N FLAP-N
Reverse (Page 39)
The SETUP LIST includes programming functions that are normally used during set up. Setup programming
functions for airplanes include those listed above.
SPEKTRUM DX6i • RADIO PROGRAMMING GUIDE
Reduce photo to 13.5% Reduce photo to 13.5%
THRO CUT RANGE CHECK
List
POSITION - ACT CHECK
Throttle Cut (Page 41) Range Check (Page 50)
Reduce photo to 13.5%
Reduce photo to 13.5%
POWER SETTING
WINGTAILMIX
List
A-EU 328
DUALAILE INH
V-TAIL INH
ELEVON INH
Power Setting (Page 52)
Wing Tail Mix (Page 43)
Reduce photo to 13.5% Reduce photo to 13.5%
CONTRAST
D/R COMBI
List
INH
50%
Contrast (Page 53)
D/R Combi (Page 46)
Reduce photo to 13.5%
Reduce photo to 13.5%
COPY/RESET
TIMER
List
MODEL 6 MUSTANG
MDL6 MUSTANG
COPY TO 1
DOWN TIMER-06:00
SURE? NO/YES
SWITCH---TRAINER
Copy/Reset (Page 55)
Timer (Page 48)
Reduce photo to 13.5%
ADJUST LIST
MODEL SELECT
Adjust List (Page 58)
List
INH
List
List
List
Main
31