Maintenance And Servicing - Central Machinery 98676 Set Up And Operating Instructions Manual

TOOL rEST (60)
EXTENSION TOOL rEST
(58)
TOOL
rEST
BODY
(56)
15. The Tool Rest (60) can also be repo-
sitioned to the Extension Tool Rest
(58) for use on outboard turnings.
(See Figure N.)
16. IMPORTANT: Make sure the Tool
Rest (60) is adjusted as close to the
workpiece as possible. Rotate the
workpiece by hand to check clear-
ance before turning on the Lathe.
FIgurE N
MAINTENANcE AND
SErVIcINg
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
SKU 98676 For technical questions, please call 1-800-444-3353.
HANDLE ASSY.
(57)
HANDLE ASSY.
(57)
FIgurE M
HANDLE ASSY.
(57)
TOOL rEST (60)
EXTENSION
TOOL rEST
(58)
FrOM AccIDENTAL
OpErATION:
Turn the power Switch (71) of
the Lathe to its "OFF" position
and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO prEVENT SErIOuS
INJurY FrOM TOOL FAILurE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
1. BEFORE EACH USE, inspect the gen-
eral condition of the Lathe. Check for
loose screws, misalignment or binding
of moving parts, cracked or broken
parts, damaged electrical wiring, and
any other condition that may affect its
safe operation.
2. AFTER USE,
of the tool with clean cloth.
3. DAILY, lubricate all external moving
parts with ISO 68 or SAE 20W oil.
4. Lubricate the Tailstock oiling point ev-
ery five uses, or once per week if used
frequently.
5. WArNINg! If the power cord (76)
of this Lathe is damaged, it must be
replaced only by a qualified service
technician.
TO prEVENT
SErIOuS INJurY
clean external surfaces
Page 15