Symbology; Specifications - Central Machinery 98676 Set Up And Operating Instructions Manual

least the minimum wire size required.
(See Table A.)
4. If you are using one extension cord
for more than one tool, add the
nameplate amperes and use the sum
to determine the required minimum
cord size. (See Table A.)
5. If you are using an extension cord
outdoors, make sure it is marked with
the suffix "W-A" ("W" in Canada) to
indicate it is acceptable for outdoor
use.
6. Make sure the extension cord is prop-
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualified electrician before using it.
7. Protect the extension cords from
sharp objects, excessive heat, and
damp or wet areas.
rEcOMMENDED MINIMuM WIrE
gAugE FOr EXTENSION cOrDS*
(120/240 VOLT)
NAMEpLATE
AMpErES
(at full load)
0 – 2.0
2.1 – 3.4
3.5 – 5.0
5.1 – 7.0
7.1 – 12.0
12.1 – 16.0
16.1 – 20.0
TABLE A
SKU 98676 For technical questions, please call 1-800-444-3353.
EXTENSION cOrD
LENgTH
18 18 18 18
18 18 18 16
18 18 16 14
18 16 14 12
18 14 12 10
14 12 10 -
12 10 - -
* Based on limiting the line
voltage drop to five volts at
150% of the rated amperes.

SYMBOLOgY

V~
A
n 0 xxxx/min.

SpEcIFIcATIONS

Electrical
Requirements
Lathe Type
Motor
Motor Speed
Spindle Speeds
(RPM)
Spindle Taper
Spindle Thread
Headstock
Adjustments
Tail Stock
16
Quill Travel
Tail Stock
14
Quill Taper
12
Tool Rest Travel
12
Swing Over Bed
-
Drive Method
-
Belt Type
-
Accessories
Net Weight
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
Volts Alternating Current
Amperes
No Load Revolutions per Minute
(RPM)
120 V~ / 60 Hz
Power Cord: 18 AWG X 3C
9.6 No Load Amps
Wood Cutting
1.0 HP
1720 RPM
670, 840, 1040, 1230, 1480, 1650, 1770,
2100, 2420, 2900
MT-2
1" Diameter x 8 TPI x 7/8" Long
Rotates at 0°, 60°, 90°, 120°, 180°
2-7/16"
MT-2
1-7/16"
14-5/8"
Belt & Pulley
0-625 V-Belt
3mm, 4mm, 6mm Hex Wrenches (1 ea.)
Dead Center (Qty. 1)
Faceplate (Qty. 1)
Flat Wrenches (Qty. 2)
282.2 Pounds
Page 8