Related Manuals for Central Machinery MINI BENCH 4019
Summary of Contents for Central Machinery MINI BENCH 4019
- Page 1 ®...
- Page 5 GRADUALLY (California Health & Safety Code 25249.5, et seq.)
- Page 6 Lathe Bed 3-Jaw Chuck internal external internal external Cover Two Speed Motor Switch larger diameter harder...
- Page 7 Cross Slide Longitudinal Slide Tool Holder Tailstock Power Switch...
- Page 8 Lathe Spindle To Assemble The 3-Jaw Chuck For A Workpiece Up To 1” Diameter: reverse internal...
- Page 9 To Assemble The 3-Jaw Chuck For A Workpiece Up To 2” Diameter: reverse external To Adjust The Tool Bit Center Height:...
- Page 10 To Adjust The Spindle Speed: accessory...
- Page 11 To Operate The Mini Bench Lathe: Then, make sure to replace the Cover.
- Page 12 Then, make sure to remove the two Pins used to tighten the jaws. Make sure the tool bit does not contact the workpiece. gradually...