Advertisement
Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
TO pREVENT SERIOUS INJURy: If the supply cord of this power tool is
damaged, it must be replaced only by a qualified service technician.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Page 16
For technical questions, please call 1-888-866-5797.
3. Periodically, wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection and blow dust out of
the motor vents using dry compressed air.
4. DAILY, lubricate all external moving
parts with ISO 68 or SAE 20W oil.
5. Lubricate the Tailstock oiling point every five
uses, or once per week if used frequently.
6.
WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Item 58358
Advertisement
