Timer Recording - Panasonic NV-VP30 Operating Instructions Manual

Timer recording

TV
VCR DVD
Automatic SP/LP
A: If, at the beginning of a timer programme, there is not enough tape remain to complete
it, the SP/LP function will automatically run the tape at LP speed. This ensures that the
entire programme will be recorded. If the LP mode is not enough to 'stretch' the remaining
tape to fit you will not be able to record all of the TV programmes.
It is not possible to automatically activate the EP mode.
VPS/PDC VPS/PDC function
If start or ending time of a programme are changed, this function synchronises the
beginning and the end of the recording session with the actual beginning and end of
the TV programme by a VPS signal of the respective station.
ON : The station transmits VPS/PDC signals. You must set the timer to the time specified
in the TV magazines. Use the special VPS time the TV magazine may indicate.
- - - : The station does not transmit VPS/PDC signals. Try to set the start and stop times
such that the entire film can be recorded even if a programme begins or ends earlier
or later than planned.
Checking the timer programme
PROG/CHECK
Press PROG/CHECK, the Timer recording menu will appear.
Press PROG/CHECK again or EXIT to quit the menu.
Changing or cancelling a timer programme
Press PROG/CHECK to display the Timer recording menu.
Press to select the entry you wish to edit, press ENTER to confirm.
Change the entries
Press CANCEL/RESET to cancel the timer programme.
Playing back programmed recordings
PROG PLAY
TOP MENU
The unit will rewind to the beginning of the programmed recording and automatically
start playing it back.
You can also play back programmed recordings manually.
selection
, press ENTER to confirm.
VCR DVD
13